Independently researched Settings Guide
XP DEUS II Settings for coins
DEUS II coin performance depends on selecting the right FMF program before editing it. General suits mixed sites, Fast dense iron, Park modern trash and Deep HC cleaner high-conductor ground.
Bottom line
Start General; use Fast in iron and Deep HC only in cleaner high-conductor sites
Ground Grab or balance as conditions require, set sensitivity below instability and tune Reactivity to target density. Keep factory discrimination and audio until you understand the program; then save one-variable changes to a user slot.
Field setup
Starting points—not universal presets
| Situation | Mode / baseline | First adjustment | Check |
|---|---|---|---|
| Mixed coin site | General | Factory Reactivity | Broad FMF baseline |
| Dense iron | Fast | Raise Reactivity only as needed | Small coil improves footprint |
| Modern trashy park | Park | Use tone/notch cautiously | Tabs overlap jewelry and some coins |
| Clean old high-conductor site | Deep HC | Lower Reactivity test | Maximum frequency limited to 14 kHz |
Adjustment method
Test the setting instead of copying it
Choose the program job
General, Fast, Park or Deep HC based on site density and targets.
Balance the ground
Use Grab/manual/tracking only where it improves ground response.
Tune Reactivity
Raise for adjacent trash; lower for sparse isolated coins.
Save controlled changes
Keep the factory program intact for comparison.
Decision analysis
What actually changes the result
Deep HC is specialized. XP combines low and medium frequencies up to 14 kHz for high conductors and coin clusters. It is not the universal choice for thin low-conductive coins.
Reactivity is the central tradeoff. Higher values separate close targets but shorten responses; lower values favor isolated depth but mask more easily.
Max Frequency changes target emphasis. XP notes that reducing it improves ground stability and iron discrimination but reduces sensitivity to weak conductors and some coins mixed with nails.
FAQ
Seven questions specific to this detector
Which DEUS II program is best for coins?
General is the broad baseline; Fast suits iron, Park modern trash and Deep HC cleaner high-conductor sites.
What is Deep HC designed for?
XP designs it for high-conductive targets and coin clusters using FMF frequencies up to 14 kHz.
What Reactivity should I use?
Use the lowest value that still separates representative adjacent targets at your sweep speed.
Should I lower Max Frequency?
Only when ground stability or iron identification improves enough to justify reduced weak-conductor sensitivity.
Is Fast deeper than General?
Not inherently. Fast prioritizes separation in iron, while General is the broader balanced program.
Should I use aggressive notch for park coins?
Only after testing local coins; notch can remove valuables sharing the same target range.
Why save edits to a user program?
It preserves the factory baseline so you can determine whether a change actually improved undisturbed targets.
Continue researching
Related detector guides
Metal Detector Settings & Target ID Guides
Continue with the related guide and compare the equipment for your terrain and targets.
Metal Detecting Guides for Beginners
Continue with the related guide and compare the equipment for your terrain and targets.
Metal Detector Comparisons
Continue with the related guide and compare the equipment for your terrain and targets.
Best XP Deus II Settings for Beach
Continue with the related guide and compare the equipment for your terrain and targets.
Use stable, repeatable settings
Record the mode, coil, firmware and ground conditions that work at your own sites.